Differences

This shows you the differences between two versions of the page.

--- tasmotabuild [2022/04/05 14:09]
rklein
+++ tasmotabuild [2022/08/09 15:20] (current)
@@ Line 1: / Line 1: @@
+=== Flash Xiaomi Mi Humi Sensors ===
+[[XiaomiHumiFlash]]
+=== Connect to tasmota via usb/serial ===
+Make sure you have miniterm installed 'sudo apt install miniterm'
+Connect the device directly vis usb or a serial to usb converter
+Enter `dmesg` too see which ttyUSB[X] device it is, where [X] is a number (probably 0)
+Crank 'miniterm /dev/ttyUSB[X] 115200 -e' into the terminal.
+Hack 'Status 11' into the terminal and see the wifi params.
+If you need to reprogramn them prepare the following line in kate (or any other text editor):
+<code>
+Backlog SSID1 yourwifi1; Password1 yourpassword1; SSID2 yourwifi2; Password2 yourpassword2; MqttHost 192.168.2.5
+</code>
+Then copy and paste it into the miniterm and hit enter.
+It should restart and connect to your wifi finally...
 === Build Tasmota from Scratch on linux ===
 ** Cli only / (no vscode needed) **
@@ Line 56: / Line 82: @@
 <code>esptool.py -p /dev/ttyUSB0 --chip esp32 --baud 921600 --before default_reset --after hard_reset write_flash -z --flash_mode dout --flash_size detect 0x0 tasmota32.bluetooth.bin
 </code>
+If compiler errors about missing dependcies show up delete your .platformio folder, which might contain files from previous platforms

mywiki x